Fixed an issue where arc input to 2D Contour could cause the toolpath calculation to fail.

Fixed a crash that could occur in some cases in 2D Contour and 2D Pocket when the input paths contained arcs.

Fixed an issue that could generate incorrect ordering in a 2D Pocket.

Updated error messages to be clearer and more informative.

Fixed a case in contour clearing in which rapid moves could cause the tool to collide with the stock.

Fixed an issue in which lead-in moves were removed incorrectly in certain cases when using the 'Trim' option for holder.

Fixed possible holder gouges or incorrect trimming in 3D Contour when using the 'Trim' option for holder and the 'Axial stock to leave' option.

Fixed a case where a toolpath wasn't calculated for contour strategies when using a tool with a shaft that was wider than the tool body.

Fixed an issue with missing offset paths for 2D Contour and 2D Pocket.

Fixed an issue where overlapping contours and contour selections with no area could cause a crash of the toolpath calculation.

Fixed an issue in some 2D Contour cases where a badly formed stay-down link could be generated when using a user defined exit position.

Fixed a crash that could occur in 2D Contour when 'Loops around corners' and 'Trimming' were enabled.

Improve the feed rate calculation when 'stock contours' are used for certain 2D strategies.

Improved support for arcs in all contour based operations.

Installation WHAT’S NEW The following changes have been made in the current update (2023.1): This document covers these Inventor CAM products: Autodesk® Inventor CAM™ 2023.1 Release Notes

Autodesk inventor cam ultimate